The Lord of the Print has some wonderful sculpts for printing, here is one of them that I more or less successfully managed to print. Sans one finger that snapped off with a support because I was not paying enough attention when removing said support.

This myconid is from their April or May 2020 patreon. I printed it on my Elegoo Mars Pro resin printer.

I painted it as follows:

Black undercoat with zenithal grey/white on top. I tried Apothecary White contrast over this, but that was not really effective at all, so I immediately while wet put on a coat of Skeleton Horde constrast. When dry, I drybrushed it carefully with Reaper MSP 09315 Ancient Bark and did a bit of shadows with Reaper MSP 09313 Rotting Wood. Dark purply reds on the cap. Base and done.

For some reason, this model makes me think of the movie Annihilation. Not sure why.

–

This mini was finished October 23th 2020

–

Painted so far this year:   (Miniatures:  265 / 365 goal // scenery and terrain: 12)

January: 32

Feburary: 19

March: 45 / 10

April: 41 // 1

May: 9

June: 20

July: 19

August: 30

September: 36 // 1

October: 15